From: Rortvedt deZero <rortvedt**At_Symbol_Here**HOTMAIL.COM>
Subject: [DCHAS-L] 3-D printers
Date: Mon, 21 Apr 2014 17:11:50 +0000
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: BAY175-W14AC7E681DDF41098FED47D75E0**At_Symbol_Here**phx.gbl
In-Reply-To



 =3BHello,

Can anyone share guidance they provide for installation and use of a 3-D printer?

Recommendations range from "use in a well-ventilated area" to housing in a HEPA-filtered encasement.

I don't have information on the size of the unit. It will be in a university art department so I assume fairly heavy use and varied feedstock.

Thanks.

Ralph

Ralph North, CHMM
Environmental Specialist
University of Wisconsin System
Office of Risk Management
780 Regent St.
Madison, WI 53715-2635
rnorth**At_Symbol_Here**uwsa.edu
(608) 263-4419

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.