Date: Thu, 28 Oct 2010 14:55:20 -0400
Reply-To: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
Sender: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
From: ILPI <info**At_Symbol_Here**ILPI.COM>
Subject: Re: Lab safety showers
In-Reply-To: <AANLkTin2B52Ufb_4UmTcYvB_57WgDY-CT27jKRzh70ua**At_Symbol_Here**mail.gmail.com>

Wow, thanks for sharing.  That one is a poster child for Bad Regulations.

1. Let's say the berm encompasses a 4' x 4' area around the shower.  That's 16 square feet, one inch high, for a volume of 1.33 cubic feet = 10 gallons.  Under ANSI Z358, showers must put out at least 20 gallons per minute.  And that shower is likely to flow for 5, if not 15 minutes.  So the berm is essentially useless.

Now, if the reg is calling for a berm that say, stretches across an entire hallway or doorway - heck, or just around the drain itself, that might work by flooding the rest of the building, as all it does is make the floor drain non-functional.  Plugging the floor drain permanently is an easier solution.

2. The amount of hazardous material on a victim is going to be so exceedingly small and so diluted in the drains that it boggles the mind.  Seriously - you get what, 10 mL of concentrated acid on you and that washes down the drain with 100 gallons of water?   Yeesh.  And if the stuff was so nasty toxic that it is a hazard even that dilue, this city review department thinks it's better to spread the hazmat all over the building and down a couple floors onto various objects and people than it is to send it down the drain.

3. When you're blinded by something and trying to find a shower on foot or on a wheelchair, even that 1" sloped bump is a barrier.  And no doubt a trip hazard the rest of time no matter how well it's marked with floor tape.

Rob Toreki

  =======================================================
Safety Emporium - Lab & Safety Supplies featuring brand names
you know and trust.  Visit us at http://www.SafetyEmporium.com
esales**At_Symbol_Here**safetyemporium.com  or toll-free: (866) 326-5412
Fax: (856) 553-6154, PO Box 1003, Blackwood, NJ 08012


On Oct 28, 2010, at 2:31 PM, Betsy Shelton wrote:

I am currently involved in construction of two new laboratories and was instructed by the city commercial building review department to include a 1" high curb around the shower area to keep hazmat from entering the floor drain in the event of a spill.  Also, the curb has to be sloped on both sides to allow accessibility.

--
Best regards,

Betsy Shelton
512.636.1905
retrosynthesis**At_Symbol_Here**gmail.com
< br>

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.