I wonder if it is primarily for humidity control.
Peter Zavon, MS, CIH
Penfield, NY
PZAVON**At_Symbol_Here**Rochester.rr.com
From: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**Princeton.EDU> On Behalf Of Natalie Merrill
Sent: Monday, April 4, 2022 7:35 AM
To: DCHAS-L**At_Symbol_Here**Princeton.EDU
Subject: [DCHAS-L] Electro polish "hot rinse" ventilation Q
Hello Colleagues,
For an electro polish system which comes equipped with good ventilation at the phosphoric acid/sulfuric acid bath, there are three more water baths in succession with the final one being warmed to 115F with deionized water. Because we have an installation of an additional ventilation trunk dedicated to the fourth (warm water) bath, which the manufacturer does not require (and isn't shown in the equipment design) I wondered what that ventilation over the water bath might be needed for?
Q: In the electro polish of stainless steels, would there be any expected evolution at the warm water rinse step? The first rinse is cool water "drag out", then a water "pre-rinse", then the final warm rinse. (This system does come complete with in-room water treatment and a large neutralization system, that is not what I'm asking about). The water supplied to the baths is filtered and deionized.
Natalie Merrill
ACS PSS
--
Natalie Merrill, ACS PSS Chair
namerrill**At_Symbol_Here**gmail.com
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
Previous post | Top of Page | Next post