From: Benjamin Ruekberg <bruekberg**At_Symbol_Here**URI.EDU>
Subject: Re: [DCHAS-L] Pressurization of 5 gallon glass carboy
Date: Fri, 25 Feb 2022 10:07:17 -0500
Reply-To: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**Princeton.EDU>
Message-ID: CAJug0OxOnn3ViCc41v3Hewi6aYMJLfk=VUt2R5hfrMt0Oq_d=g**At_Symbol_Here**mail.gmail.com
In-Reply-To


I have some questions which may be relevant. (FYI, I seem to recall glass vessels for vacuum that were generously wrapped in electrical tape. Poor man's safety glass, I guess.)

Will the carboys in question conveniently fit in a metal trash can, 5 gallon solvent can, or waste basket? If so, with a suitable cover, would that not make the use of the carboys sufficiently safe? If non-metal versions of these containers are available, with room to fill the space between the carboy and the container wall with water (and means to hold the carboy down), could that be considered safe?

If the cost is not excessive, could the carboys be cast in acrylic to reinforce the glass? Screw eyes could be inserted in the plastic to secure the stopper, possibly with springs to prevent over-pressurization.

In essence, I guess, what I am asking is whether the carboys might be rendered safe?

Another consideration is that if the carboy is filled with water, the pressure at the bottom will be a function of the height of the water. If turning the carboy upside-down mutatis mutandis. Clearly, if that pressure is not exceeded, there should not be a problem.

Thank you very much,

Ben

On Fri, Feb 25, 2022 at 9:07 AM Michael <mabuczynski**At_Symbol_Here**hotmail.com> wrote:
As a reminder-


- We should ALWAYS examine the glassware before we use it before we are about to set up. I have seen where a scratch in a beaker caused it to shatter during an experiment /process.

Mike Buczynski
Principal Owner
PSCR Services LLC.

From: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**Princeton.EDU> on behalf of Ralph Stuart <ralph.stuart**At_Symbol_Here**KEENE.EDU>
Sent: Friday, February 25, 2022 8:40 AM
To: DCHAS-L**At_Symbol_Here**Princeton.EDU <DCHAS-L**At_Symbol_Here**Princeton.EDU>
Subject: Re: [DCHAS-L] Pressurization of 5 gallon glass carboy
My thanks to everyone for sharing their thoughts on my question yesterday. I want to point out that the faculty member asked for my help in assessing this risk rather than just ignoring the various warnings etched into the glass by the manufacturer.

The question arose because the member had detected defects in the existing carboys, which are likely to be 40 years old, and had ordered replacements, which included 6 vague warnings, including the reference to the technical information that we couldn't find on their web site. The suggestion to talk to a company rep is the next step.

It is helpful to be reminded of the energy levels involved in pressurized gases, but that was not news to either of us. I do appreciate having the stories people shared with me about bad experiences they've had with similar set ups.

Thanks to everyone for their assistance with this question.

- Ralph

Ralph Stuart, CIH, CCHO
Environmental Safety Manager
Keene State College
603 358-2859

ralph.stuart**At_Symbol_Here**keene.edu

---
For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org
Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.