I had one of those at a pervious employer. They’re more expensive, but worth it because people do have a bad habit of assuming they can put any chemical in a chemical designated fridge.
Also, be purposeful about your fridge signs. I had someone put their “edible chemical mixtures” in the chemicals fridge because “the food fridge was full”. Needless to say, it prompted improvements to our posted signs.
Thank you,
Yaritza Brinker
260.827.5402
From: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**Princeton.EDU>
On Behalf Of Richard Palluzi
Sent: Monday, February 15, 2021 11:21 AM
To: DCHAS-L**At_Symbol_Here**Princeton.EDU
Subject: Re: [DCHAS-L] Refrigeration in Chemical Stockrooms
** External Email **
You can buy models that are suitable for flammable storage (interior) and rated for an electrically classified area (exterior).
Richard Palluzi
PE, CSP
Pilot plant and laboratory consulting, safety, design, reviews, and training
www.linkedin.com/in/richardppalluzillc/
Richard P Palluzi LLC
72 Summit Drive
Basking Ridge, NJ 07920
rpalluzi**At_Symbol_Here**verizon.net
908-285-3782
From: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**Princeton.EDU>
On Behalf Of Tom O. Spicer III
Sent: Monday, February 15, 2021 11:11 AM
To: DCHAS-L**At_Symbol_Here**Princeton.EDU
Subject: Re: [DCHAS-L] Refrigeration in Chemical Stockrooms
About a refrigerator rated for flammable storage, my understanding is that the rating generally applies to the cold storage space and not outside the refrigerator. Something to check. Best regards, ts
On 2/15/2021 8:51 AM, Richard Palluzi wrote:
First check with your facility people or the original building drawings to make sue the room was not permitted as a solvent storage room in which case it May have been required to be an electrically classified area per the National electric code. (Which could be why there is no power there now.) If it is electrically classified there are a lot of requirements you need to meet that are best addressed outside this discussion.
Assuming it is not permitted as a solvent storage room then the basic issue is if there is a credible risk of building up enough vapors in the area that you can create an ignitable concentration. If the room is used for dispensing, transfers, or other open activities involving flammable materials then there is a good chance this needs to be evaluated carefully by a knowledgeable professional.
If the room is used just for storage then the next question is how well ventilated is it as there will always be some vapors emitted over time. Typically you require 1 CFM/SF of floor area minimum with at least 500 CFM. If you have that amount then you are probably OK for just storage. If you don’t then you need to evaluate your specific situation.
Assuming you have enough ventilation then a standard outlet is allowed. If the refrigerator is never to handle any flammable materials, ever, and you feel sure you can ensure that it can be a standard refrigerator. I would, however, always recommend it be one designed for storage of flammables as I find that keeping them out over time is problematic.
You can feel free to call me with any specific questions.
Richard Palluzi
PE, CSP
Pilot plant and laboratory consulting, safety, design, reviews, and training
www.linkedin.com/in/richardppalluzillc/
Richard P Palluzi LLC
72 Summit Drive
Basking Ridge, NJ 07920
rpalluzi**At_Symbol_Here**verizon.net
908-285-3782
From: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**Princeton.EDU> On Behalf Of Nora Dunkel
Sent: Monday, February 15, 2021 9:31 AM
To: DCHAS-L**At_Symbol_Here**Princeton.EDU
Subject: [DCHAS-L] Refrigeration in Chemical Stockrooms
Hello Colleagues,
Some faculty at my institution have asked whether we can install a fridge in the chemical stockroom for reagents that need to be stored between 2 and 8 C. Currently, there are no electrical outlets in the stockroom.
Flammable materials, corrosives, and the usual miscellaneum of oxidizers and toxics are all stored in this space (in appropriate cabinets, of course!).
I have two major questions:
- Would installing an electrical outlet in a room where flammable materials are stored (in unvented cabinets) require the electrician to do anything out of the ordinary? Do the receptacles need to be hospital grade? What else should I be aware of? Should I temporarily move the flammable materials to another room while the outlet is being installed?
- If none of the materials to be stored in the fridge are flammable, would a ‘regular’ lab fridge suffice? Or should it be rated for flammables storage given its proximity to flammable material?
Thanks for your help,
Nora Dunkel
Chemical Safety Officer
Webster University
Office: Browning Hall/ISB 314
314-246-2244 (desk)
661-348-1445 (cell)
noradunkel51**At_Symbol_Here**webster.edu
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at
membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at
membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
The information
contained in this electronic transmission is private, confidential, the property of the sender, and intended for the use of the recipient(s),
only. If you are not the addressee, any disclosure, copying, distribution or use of this information for any purpose is strictly
prohibited. If you have received this information in error, please notify the sender,
YBrinker**At_Symbol_Here**fele.com, immediately by e-mail and then delete this message. Thank you.
[FE.EN.1]
Previous post | Top of Page | Next post