From: "Bell,Martin" <mwb32**At_Symbol_Here**drexel.edu>
Subject: [DCHAS-L] Metal Additive Manufacturing
Date: Fri, 3 May 2019 21:19:44 +0000
Reply-To: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**PRINCETON.EDU>
Message-ID: E0A62FB5-11E1-44A1-BF86-AF92E28FF3F7**At_Symbol_Here**drexel.edu


I was just informed a researcher received a grant that includes the use of 3D metal printer. I was wonder if someone can share the types of engineering controls implemented to address the reactive metal powders used in the printer.

 

Martin

 

Martin W. Bell, M.S. CIH CSP 

Director, Environmental Compliance

Department of Environmental Health and Safety

 

Drexel University

400 North 31st Street

Philadelphia, PA 19104

Tel: 215.895.5892 | Fax: 215.895.5926

Mobile: 215-778-4278

drexel.edu/facilities/healthsafety

 

 

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.