From: Eugene Ngai <eugene_ngai**At_Symbol_Here**COMCAST.NET>
Subject: Re: [DCHAS-L] Attaching a regulator with a washer...
Date: Fri, 11 Jan 2019 05:09:51 -0500
Reply-To: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**PRINCETON.EDU>
Message-ID: 016a01d4a995$cb146640$613d32c0$**At_Symbol_Here**comcast.net
In-Reply-To <201901102327.x0ANRvg1009501**At_Symbol_Here**ppa03.princeton.edu>


=BD of the CGA connections are gasket type. These are primarily for low pressure liquefied gases

 

From: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**PRINCETON.EDU> On Behalf Of Richard Palluzi
Sent: Thursday, January 10, 2019 6:28 PM
To: DCHAS-L**At_Symbol_Here**PRINCETON.EDU
Subject: Re: [DCHAS-L] Attaching a regulator with a washer...

 

I would check with the gas supplier. Few CGA connections have washers. Most are fir very toxic or corrosive gases. You may have the wrong type connection on the regulator. Everyone I have ever seen with a washer has a female port so the washer is just pushed in place and then the regular screwed in place.

 

Sent from my Verizon Wireless 4G LTE Droid

On Jan 10, 2019 12:04 PM, Margaret Rakas <mrakas**At_Symbol_Here**SMITH.EDU> wrote:

Hi,

 

I am looking for some practical advice (or maybe sympathy...)

 

We recently purchased a new regulator for CO2 tanks; this particular regulator has a washer and the accompanying manual says if the regulator comes with a washer, to use the washer.  I have attached regulators for more years than I care to count, but this is my first with a washer....

 

I was doing a training session for the end users and it turned out to be more of a physical comedy show, as the washer kept falling off/out of the coupling 'thingie'.  The tank is in a tricky space, but there is really nothing to hold the washer in place and the vendor's rep said using a bit of tape or other sticky material to tack it in place on the regulator side of the fitting was not OK.   We ended up not having the right attachment for an accessory so used the old setup.  Now we have the complete ensemble all set to go.

 

Does anyone have any 'tricks' or advice in how I can attach the regulator keeping the washer in place without looking like a complete klutz?

many thanks!
Margaret

 

--

Margaret A. Rakas, Ph.D.
Manager, Inventory & Regulatory Affairs
Clark Science Center
413-585-3877 (p)

--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas

--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.