| About This Archive | | DCHAS-L 2018 Index | | DCHAS-L Yearly Index | |
Check out Safety Emporium for your N95, N99, and face shield needs.
|
Previous by Date: Subject: Re: [DCHAS-L] Emergency Shower and Eyewash Temperatures Date: Friday, July 6, 2018 at 2:23:45 PM Author: Tyrell Towle <tyrelltowle**At_Symbol_Here**GMAIL.COM> |
Next by Date: Subject: Re: [DCHAS-L] Emergency Shower and Eyewash Temperatures Date: Fri, 6 Jul 2018 12:26:48 -0700 Author: mail**At_Symbol_Here**ECHELONENVIRONMENTAL.NET |
At Western Technical College, the naturally hard water causes the mixing valves to lime up if the water in the eye wash isn't run regularly. So, one summer, when I wasn=E2=80™t working, and the custodial staff was supposed to be testing the eye washes and showers, but weren't actually doing it, the mixing valves failed. The water temp was too high, and they replaced the mixing valves. Another year, when they were remodeling the stockroom, the eyewashes were off for a whole two months, and again the valves failed, and this time the water was all cold. So, either way, due to the hard water in LaCrosse WI, the mixing valves could lime up in just a couple months, and then fail.
This is why we test them.
Meg
Meg Osterby
W831 County Road K
Stoddard, WI 54658
414-539-1543 (cell)
608-788-7951 (home)
megosterby**At_Symbol_Here**gmail.com
"It's better to be careful 100 times than to be killed once." Mark Twain
From: Chance, Brandon
Sent: Friday, July 6, 2018 1:08 PM
To: DCHAS-L**At_Symbol_Here**PRINCETON.EDU
Subject: Re: [DCHAS-L] Emergency Shower and Eyewash Temperatures
Also, remember that mixing valves fail. I have had situations where mixing valves that served all of the units on a floor have failed on the hot side, resulting in a complete system having water above 120F. We have asked our Facilities group to ensure the valves are part of the building preventative maintenance plan after we had to rebuild or replace a number of them.
Regards,
Brandon S. Chance, MS, CCHO
Director of Environmental Health and Safety
Sustainability Committee Chair
Office of Risk Management
Southern Methodist University
PO Box 750231 | Dallas, TX 75275-0231
T) 214.768.2430 | M) 469-978-8664
"- our job in safety is to make the task happen, SAFELY; not to interfere with the work-" Neal Langerman
From: ACS Division of Chemical Health and Safety on behalf of Penny Manisco
Reply-To: ACS Division of Chemical Health and Safety
Date: Thursday, July 5, 2018 at 6:14 PM
To: "DCHAS-L**At_Symbol_Here**PRINCETON.EDU"
Subject: Re: [DCHAS-L] Emergency Shower and Eyewash Temperatures
Hi All,
This is so weird because this exact thing happened in one of our newly renovated labs. A few weeks ago I was instructing students on flushing eyewash and safety shower and noticed the shower was scalding hot. The eyewash/shower had been installed last summer and has been fine all year. I checked a second system in that lab only to find that the shower was not functioning at all. It turned out that someone (contractors remodeling a restroom perhaps?) had erroneously turned off the cold water valve that feeds the emergency equipment. That caused scalding water at one end of the room, and no pressure at the other. The eyewash and shower are fed with water from a mixing valve.
This is why we check!
Best,
Penny Manisco
Chemical Hygiene Officer
Harvey Mudd College
On Thu, Jul 5, 2018 at 2:14 PM, Tyrell Towle <Tyrell**At_Symbol_Here**medpharmholdings.com> wrote:
Hello everyone,
This may seem like a basic question, but I am getting some pushback from our plumbing contractors on this.
We have a brand new facility and I went through to test all of the eyewash and emergency shower stations. At first everything seemed to be working fine, but then I noticed that the emergency eyewash water was getting warmer. I was horrified when the eyewash water became hot. I have never encountered hot eyewash water before. I had the contractors re-plumb the eyewash stations into cold tap water only. Now they are pushing back, wanting to hook the eyewash stations back into the hot water.
I also noticed that our emergency shower is releasing hot water.
Are there any regulations surrounding eyewash and emergency shower temperatures? My understanding has always been to have cold, potable tap water running into emergency showers and eyewashes so that chemical reactions are not accelerated upon exposure to heat. Regardless, with the temperatures that our eyewash stations were reaching, there was no way that anyone could keep their eyeballs open for 10 minutes in this water. Any information is appreciated, especially information that will put this debate to rest.
Thank you!
Tyrell R. Towle, Ph.D.
Senior Chemist
MedPharm Holdings, LLC
www.medpharmholdings.com
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--
Penny Manisco,
Chemical Hygiene Officer
Harvey Mudd College
(909)6074217
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
--- For more information about the DCHAS-L e-mail list, contact the Divisional membership chair at membership**At_Symbol_Here**dchas.org Follow us on Twitter **At_Symbol_Here**acsdchas
Previous post | Top of Page | Next post