From: Ellen M. Sweet <ems325**At_Symbol_Here**cornell.edu>
Subject: [DCHAS-L] sodium azide use in HPLC
Date: Mon, 27 Feb 2017 15:56:41 +0000
Reply-To: ACS Division of Chemical Health and Safety <DCHAS-L**At_Symbol_Here**PRINCETON.EDU>
Message-ID: DM5PR04MB07642AA633FE98ED4B719C099A570**At_Symbol_Here**DM5PR04MB0764.namprd04.prod.outlook.com


Hello everyone,

I have a question from a faculty member and I need some help with my assessment on whether this is safe to do.

 

“I have an experiment where I used sodium azide at very low concentrations (0.01 mM/0.000065%, to inhibit an enzyme) and I'm wondering if this is okay to go in the HPLC (the eluent is 0.25% phosphoric acid). I only inject 15 uL of my sample into the HPLC per run, but I know interactions with acid can create toxic gases, so I just wanted to check about the best way to measure these samples and what safety precautions would be recommended for these concentrations.”

 

 

In looking at the SDS there are statements such as “reacts violently with acids” and “incompatible with metals and solvents”.

With the concentration this low, will this cause a problem? If so, is there an alternative?

 

Thanks, Ellen

 

 

Ellen Sweet

Laboratory Ventilation Specialist

Department of Environmental Health and Safety, Cornell University

American Chemical Society, Division of Chemical Health and Safety

315-730-8896

 

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.