I hope you the booth is not actually in the wood shop. Flammable vapors are incompatible with combustible dusts.
I've never seen a fan with that much delay. But I have seen systems with the fan at the end of a long duct that takes a long time to develop a enough negative pressure to create a breeze. Have you seen the mechanical plans?
Most spray booths run only on demand since they exhaust a lot of cfm. Multiply the area of the face by a minimum velocity of 100 ft per minute. No system can afford to hurl that amount of air out the stack.
Monona
Sent from my iPhone
> On Nov 9, 2016, at 3:56 PM, Stuart, Ralph ---
Previous post | Top of Page | Next post
>
> I have a exhaust fan design question that someone in this group may be able to comment on. We have a spray paint booth in our wood shop (2014-vintage) with a lab style fan (Vektor-H Laboratory Exhaust System - Greenheck Fan) on it. It is turned on and off as needed with a off/low/high switch, but when we turn it on, there is no apparent response for about 5 minutes. This makes it difficult to convince the booth users that the system is working, since they may complete their work in the booth (e.g. spray painting a piece) before the system is fully operational.
>
> I realize that most lab fan systems are on 24/7, but I wonder if anyone has run into similar situations with systems which are designed to be turned on and off routinely?
>
> Thanks for any thoughts about this.
>
> - Ralph
>
> Ralph Stuart, CIH, CCHO
> Chemical Hygiene Officer
> Keene State College
>
> ralph.stuart**At_Symbol_Here**keene.edu
>
> ---
> This e-mail is from DCHAS-L, the e-mail list of the ACS Division of Chemical Health and Safety.
> For more information about the list, contact the Divisional secretary at secretary**At_Symbol_Here**dchas.org
This e-mail is from DCHAS-L, the e-mail list of the ACS Division of Chemical Health and Safety.
For more information about the list, contact the Divisional secretary at secretary**At_Symbol_Here**dchas.org