From: ILPI Support <info**At_Symbol_Here**ilpi.com>
Subject: Re: [DCHAS-L] Glassware inspection guide?
Date: Wed, 2 Sep 2015 15:59:35 -0400
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: FECEE04B-BE6D-4C17-81CC-33303DEEEBBE**At_Symbol_Here**ilpi.com
In-Reply-To <7B3E35D0-FF0C-4C73-981E-B6BA24B1F12E**At_Symbol_Here**keene.edu>


Not very illustrated but this one covers a range of defects http://www.qorpak.com/lab-glass-defects-inspect-packaging.aspx

Stuff that needs more careful attention is anything that will be subjected to vacuum or pressure.   Items immersed into cryogens would also merit special attention.  Any of these could explode or shatter with disastrous results.

On high vac systems you can often find leaks (especially hairline or star cracks) using a handheld Tesla (high frequency) coil when the system is under vacuum.  These are still sold by places like VWR for under $300.

Any glassware that has been repaired as a DIY project (e.g. no in-house glassblower to properly anneal the piece) should be examined with a polariscope to ensure that stress/strain has been properly relieved.  See http://www.ilpi.com/glassblowing/glassstress.html  Be sure to check out that link to the Corning Museum of Glass video at the bottom of the page for an example of annealed glass spontaneously shattering.

Chips out of beaker and test tube lips are a common source of sharp edges.  I'd imagine that in many classroom student equipment drawers there are a lot of these and the students are loathe to report them so they do not get charged for breakage.

Rob Toreki

 ======================================================
Safety Emporium - Lab & Safety Supplies featuring brand names
you know and trust.  Visit us at http://www.SafetyEmporium.com
esales**At_Symbol_Here**safetyemporium.com  or toll-free: (866) 326-5412
Fax: (856) 553-6154, PO Box 1003, Blackwood, NJ 08012



On Sep 2, 2015, at 3:29 PM, "Stuart, Ralph" <Ralph.Stuart**At_Symbol_Here**keene.edu> wrote:

Does anyone know of a good illustrated guide to inspecting lab glassware for potential safety concerns? I've seen a fair amount of advice on the web that says "inspect glassware before using" but I'd like to have some examples of things to look for. Also, are there specific locations on different types of glassware that should be examined more carefully than others?

Thanks for any help with this.

- Ralph


Ralph Stuart, CIH, CCHO
Chemical Hygiene Officer
Keene State College

ralph.stuart**At_Symbol_Here**keene.edu


Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.