From: "Secretary, ACS Division of Chemical Health and Safety" <secretary**At_Symbol_Here**DCHAS.ORG>
Subject: [DCHAS-L] MSDSs on 3D printer consumables
Date: Sat, 14 Jun 2014 20:00:30 -0400
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: 10ACB1C9-CD3C-4587-9A7E-E39B1319E817**At_Symbol_Here**dchas.org


From: Monona Rossol
Re: MSDSs on 3D printer consumables

Well, I've about run out of ideas on how to get the MSDSs on 3D printer consumables. I'm trying to set up ventilation for two models:

1. The DWS 008J Digital wax manual makes the resin sound like death on a stick. Touch it only with gloves. If it gets on the skin, head for hospital. Wear respirator or die. But the company is in Thailand as far as I can see. And the distributor for the one bought by the school I'm on a job for says "MS....what?"

2. The other one is Z Corp 350 ZPrinter.

And anyone who thinks people aren't touching and snorting the powders only has to see one of these after it has been in operation for a while. You can write you name on the damn things.

Any help would be much appreciated


Monona Rossol, M.S., M.F.A., Industrial Hygienist
President: Arts, Crafts & Theater Safety, Inc.
Safety Officer: Local USA829, IATSE
181 Thompson St., #23
New York, NY 10012 212-777-0062
actsnyc**At_Symbol_Here**cs.com www.artscraftstheatersafety.org

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.