From Sigma Aldrich SDS on CAS #631-57-2
Sammye
Skin protection
Handle with gloves. Gloves must be inspected prior to use. Use
proper glove removal technique (without
touching glove's outer surface) to avoid skin contact with this
product. Dispose of contaminated gloves after
use in accordance with applicable laws and good laboratory
practices. Wash and dry hands.
Full contact
Material: butyl-rubber
Minimum layer thickness: 0.3 mm
Break through time: 480 min
Material tested:Butoject® (KCL 897 / Aldrich Z677647, Size M)
Splash contact
Material: butyl-rubber
Minimum layer thickness: 0.3 mm
Break through time: 480 min
Material tested:Butoject® (KCL 897 / Aldrich Z677647, Size M)
data source: KCL GmbH, D-36124 Eichenzell, phone +49 (0)6659 87300,
e-mail sales**At_Symbol_Here**kcl.de, test method:
EN374
If used in solution, or mixed with other substances, and under
conditions which differ from EN 374, contact the
supplier of the CE approved gloves. This recommendation is advisory
only and must be evaluated by an
industrial hygienist and safety officer familiar with the specific
situation of anticipated use by our customers. It
should not be construed as offering an approval for any specific use
scenario.
Body Protection
Complete suit protecting against chemicals, Flame retardant
antistatic protective clothing, The type of
protective equipment must be selected according to the concentration
and amount of the dangerous substance
at the specific workplace.
Acetyl cyanide
Samuella B. Sigmann,
NRCC-CHO
Lecturer/Safety Committee Chair
A. R. Smith Department of Chemistry
Appalachian State University
525 Rivers Street
Boone, NC 28608
Phone: 828 262 2755
Fax: 828 262 6558
Email: sigmannsb**At_Symbol_Here**appstate.edu
Previous post | Top of Page | Next post