From: Rita Kay Calhoun <r.calhoun**At_Symbol_Here**MOREHEADSTATE.EDU>
Subject: Re: [DCHAS-L] Occupancy sensors in laboratories
Date: Fri, 11 Apr 2014 16:24:48 +0000
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: 081D54673FDDB347BC1F77943BC7C7FA0191E42C**At_Symbol_Here**mx-mb-1.morehead-st.edu
In-Reply-To <2052AE83F0ECCE4B9737994B4E529D4E2C01A007**At_Symbol_Here**IU-MSSG-MBX108.ads.iu.edu>


Lee,

                The obvious solution is to not have occupancy sensors in labs.  This is actually a safety issue, and safety must trump energy-saving endeavors.  I know administrators/management only want to look at the bottom line, but that’s not always possible.  We have occupancy sensors in our offices and bathrooms, but not our labs.  There are 2 possible fixes I can think of which might work, but will of course involve some rewiring and therefore money.  First, wire one light in each lab as an emergency light that is always on.  That way the lab personnel at least have enough light to see by until they get a chance to “get up and wave” at the sensor.  The second is an override switch that can be turned on when the lab personnel are performing more stationary tasks.

 

Good Luck,

Kay

 

From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU] On Behalf Of Stone, Kenneth Lee
Sent: Friday, April 11, 2014 9:25 AM
To: DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU
Subject: [DCHAS-L] Occupancy sensors in laboratories

 

Has anyone had issues with occupancy sensors in laboratories?  We have a new research building on campus and one of the steps taken to achieve LEED certification was to install occupancy sensors in all the laboratories.  We are now having issues with the lights going off when the laboratory is occupied.  This is a concern for me, particularly when we have employees working in biosafety cabinets and fume hoods and the lights go out.  Laboratory work typically does not involve large amounts of movement and we teach our researchers not to make quick or exaggerated  movements when working in our biosafety cabinets and fume hoods, so these sensors are having difficulty detecting  movement and are shutting the lights off.   I am hoping some of you have experienced the same problem and can provide recommendations on how to resolve the issue.

 

Your feedback is greatly appreciated.

 

Kind regards,

 

Lee

 

K. Lee Stone M.S., MT (ASCP), NRCC-CHO

Laboratory Safety Manager

Chemical Hygiene Officer

President- IUPUI Staff Council

My Page

 

 

Lockefield Village

980 Indiana Avenue, Room L4430

Indianapolis, IN 46202

317-278-6150 (T)  |  (317) 278-2158 (F)  | 

IUPUI-Environmental Health and Safety

 

Problems cannot be solved at the same level of awareness that created them.
- Albert Einstein (1879-1955)

We Value your opinion.  Please provide feedback here.

 

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.