From: Jeffrey Lewin <jclewin**At_Symbol_Here**MTU.EDU>
Subject: Re: [DCHAS-L] laminar flow hood purchase
Date: Thu, 7 Nov 2013 11:39:29 -0500
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: CAEwQnqiVJAhuzdm9XCnU-OgYspy43JxDXZT32mEdpPsNO5pKaQ**At_Symbol_Here**mail.gmail.com
In-Reply-To <9F3B003643FC5F42930EFB83E276C8600252C434FF6A**At_Symbol_Here**HNXEXCH.hendrix.local>


Shelly,

Make sure the activity is appropriate for a laminar flow hood and not a Biological Safety Cabinet.

The former blows HEPA filter air out of the cabinet into the face of the user. It is designed to keep the activity sterile but NOT protect the user. They are used in biology primarily for pouring sterile petriplates, culturing of non-pathogenic and non-allergenic cultures, etc. They also get used in electronics and other industries in clean rooms.

If they are working on pathogenic cultures, or need to protect the user from the work they are doing, then you need a biological safety cabinet (BSC). They provide HEPA filtered air to keep the cultures from getting contaminated as well as HEPA filtered exhaust air. BSC's can exhaust into the room (cheaper) or into dedicated ductwork.

Laminar flow hoods should be clearly labeled to not be used for pathogenic work.

Note that many laminar flow (as well as BSC's) often use UV lights to sterilize the surface of the units. Putting the discussion of the effectiveness of this sterilization procedure aside, since most laminar hoods do not have a sash, they need other protective measures to prevent UV exposure to the worker. In BSC's, a secondary protection is to put a sash height detector to kill the UV light if it gets opened before the light is turned off.

Finally, BSC's should be calibrated and checked by a certified professional and should be re-certified annually.

Jeff Lewin
Biological Sciences
Michigan Technological University




On Thu, Nov 7, 2013 at 11:11 AM, Bradley, Shelly <Bradley**At_Symbol_Here**hendrix.edu> wrote:
One of my faculty is interested in a laminar flow hood. I know nothing about them.
What do I need to know?
Are the self-contained ones any good?
Which brands are best?

Thanks for your help!!

Shelly Bradley
NRCC-CHO
Authorized OSHA Trainer
Instrumentation Specialist
Laboratory Development Assistant
Campus Chemical Compliance Director
Department of Chemistry
Hendrix College
Conway, AR 72032
Ph: (501) 450-3812
Fax: (501) 450-3829
bradley**At_Symbol_Here**hendrix.edu

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.