Angular blast shields are available for this purpose. We incorporated the use of this when we had to run our Hydrogenator (the good ‘ol Parr Shaker!)
http://www.coleparmer..com/Product/Scienceware_Weighted_safety_shield_30_height/WU-86469-10
A VBE (Ventilated Balance Enclosure might work as well.
But I would like to know why can this line (sounds like a Schlenk line to me) cannot be used within the hood?
Hope this helps.
Cheers!
-George
***************************************
George D. McCallion
Chemist/Environmental Health & Safety
3250-B, St. Peters Rd.
St. Peters, PA 19470-0387
Office: 610.469.6543, ext. 104
Fax: 610.469.6547
Email:
GMcCallion**At_Symbol_Here**Storedenergyconcepts.com
***************************************
From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU]
On Behalf Of Kimberly Bush
Sent: Wednesday, August 28, 2013 9:31 AM
To: DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU
Subject: [DCHAS-L] Shielding for large vacuum-manifold?
[Multiposting. My apologies if you’re seeing this in duplicate.]
Has anyone seen, developed, or researched solutions for shielding laboratory-scale vacuum manifolds for pulling high vacuum on glass vessels? This would be a large (approx. 10-foot wide) glass manifold that would not be located inside
of a fume hood. We want to reduce the hazard of flying glass in the event of a glassware failure and resulting implosion.
While this particular apparatus is part of a renovation for a new research group, we have some similar equipment on our academic campus that could benefit from the same kind of solution.
Sliding panels/doors? Enclosures? Hanging blast shields? Anything like this in use?
Kimi Bush
Lab Safety Specialist
Environmental Health and Radiation Safety
University of Pennsylvania
3160 Chestnut St., Suite 400
Philadelphia, PA 19104-6287
Google Voice/cell/text: 215-360-3KIM
fax: 215-898-0140
Previous post | Top of Page | Next post