From: ILPI Support <info**At_Symbol_Here**ilpi.com>
Subject: Re: [DCHAS-L] demolition of lab with osmium tetroxide contamination
Date: Mon, 5 Aug 2013 17:10:28 -0400
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: 3C2BD305-E3B1-4BC1-BE7A-087348E8338F**At_Symbol_Here**ilpi.com
In-Reply-To


Not an expert at that, but for the hood I'd go with a full face supplied air respirator.  While it's unlikely there is anything volatile remaining, OsO4 attacks the corneas and I would not rely on a cartridge which probably has not been tested against Os4.


Rob Toreki

  ======================================================
Safety Emporium - Lab & Safety Supplies featuring brand names
you know and trust.  Visit us at http://www.SafetyEmporium.com
esales**At_Symbol_Here**safetyemporium.com  or toll-free: (866) 326-5412
Fax: (856) 553-6154, PO Box 1003, Blackwood, NJ 08012

On Aug 5, 2013, at 3:29 PM, Ellen M. Sweet <ems325**At_Symbol_Here**CORNELL.EDU> wrote:

Hi everyone,
I'd like to know if anyone has dealt with the demolition of a lab and removal of a fume hood in which osmium tetroxide was used? Other than recommending respiratory protection (N100 or P100 cartridges), nitrile gloves and coveralls during tear-out, are there any other precautions we should keep in mind?
Thanks for any suggestions.
Ellen
 
Ellen Sweet
Laboratory Ventilation Specialist
Department of Environmental Health and Safety
Cornell University
315-730-8896
 

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.