From: Karen Salazar <kls_1**At_Symbol_Here**COX.NET>
Subject: Re: [DCHAS-L] Update on theatrical blood bath
Date: December 18, 2012 1:50:22 PM EST
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: <17ec3.5bba2453.3e01fdf5**At_Symbol_Here**cs.com>


I have no idea, but I was just thinking about the wear and tear of the system.  Are the tubing and pumps rated for transfer at 90 degrees?  Are they susceptible to break-down at those temps?  These may or may not be issues, but I was thinking it would be best to find out before showtime.


Karen 


On Dec 18, 2012, at 11:12 AM, ACTSNYC**At_Symbol_Here**CS.COM wrote:

They plan to heat to whatever temp is needed and hold for the time needed and then let the stuff cool down so the pumps would be handling stuff at 90 o F.  That should be OK, you think?   Monona


In a message dated 12/18/2012 8:10:09 AM Eastern Standard Time, kls_1**At_Symbol_Here**COX.NET writes:

Monona,

I hope you are able to find a solution now that the CDC is on the case; however, if you plan to use heat as the solution, I just wanted to remind you to take precautions concerning possible mechanical failure of the pumping system as well. 


Good Luck,
Karen




Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.