From: "Debbie M. Decker" <dmdecker**At_Symbol_Here**UCDAVIS.EDU>
Subject: Re: [DCHAS-L] Cadaver lab ventilation; Dissection tables for 1) cadavers and 2) animals
Date: February 2, 2012 7:44:51 PM EST
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Message-ID: <BE28425130279043A5B92A2BC7116E23520398**At_Symbol_Here**EXCH-MBOX-1.exch.ucr.edu>


We did the same thing in our new human anatomy lab.  The instructor and students like ‘em, our embalmers like ‘em and our IH who did the formaldehyde exposure monitoring likes ‘em.  A bit of training to make sure the side slots are kept clear and it’s all good.

 

 

Debbie M. Decker, Campus Chemical Safety Officer
Environmental Health and Safety
University of California, Davis
1 Shields Ave.
Davis, CA  95616
(530)754-7964/(530)681-1799 (cell)

(530)752-4527 (FAX)
dmdecker**At_Symbol_Here**ucdavis.edu
Co-Conspirator to Make the World A
Better Place -- Visit www.HeroicStories.com and join the conspiracy

 

 

 

From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU] On Behalf Of Russell Vernon
Sent: Thursday, February 02, 2012 9:08 AM
To: DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU
Subject: Re: [DCHAS-L] Cadaver lab ventilation; Dissection tables for 1) cadavers and 2) animals

 

We recently remodeled our Gross Human Anatomy Lab with down-draft tables which are reducing the formaldehyde in the air dramatically. We followed the ‘side-slot’ design that University of Nevada found most effective.

-Russ

 

Russell Vernon, Ph.D.

Director

Environmental Health & Safety

University of California, Riverside

900 University Ave

Riverside, CA 92521

www.ehs.ucr.edu

russell.vernon**At_Symbol_Here**ucr.edu

 

Direct (951) 827-5119

Admin (951) 827-5528

Fax (951) 827-5122

 

http://www.ucop.edu/riskmgt/uctrips/

 

From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU] On Behalf Of Ferm, Barret
Sent: Thursday, February 02, 2012 7:32 AM
To: DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU
Subject: [DCHAS-L] Cadaver lab ventilation; Dissection tables for 1) cadavers and 2) animals

 

I am seeking information regarding ventilation methods for a cadaver laboratory.  In particular, we want to know the best way to achieve low formaldehyde levels, closer to the NIOSH recommended level of 0.016 ppm-TWA.  Also, any specific precedence or references you can share to help me inform/educate the decision makers why it is (or is not) in the institution's best interest to go by the NIOSH  values rather than the OSHA values (0.75 ppm TWA for formaldehyde).
All this is in the context of a renovation and expansion.  Any information on this would be greatly appreciated, including vendors for down-draft tables or other engineering control techniology (reviews, good+bad).   Thanks!

Barry Ferm, CHO & Lab Coordinator, St. Ambrose University, Davenport Iowa, fermbarreta**At_Symbol_Here**sau.edu

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.