We recently remodeled our Gross Human Anatomy Lab with down-draft tables which are reducing the formaldehyde in the air dramatically. We followed the ‘side-slot’
design that University of Nevada found most effective.
-Russ
Russell Vernon, Ph.D.
Director
Environmental Health & Safety
University of California, Riverside
900 University Ave
Riverside, CA 92521
russell.vernon**At_Symbol_Here**ucr.edu
Direct (951) 827-5119
Admin (951) 827-5528
Fax (951) 827-5122
http://www.ucop.edu/riskmgt/uctrips/
From: DCHAS-L Discussion List [mailto:dchas-l**At_Symbol_Here**MED.CORNELL.EDU]
On Behalf Of Ferm, Barret
Sent: Thursday, February 02, 2012 7:32 AM
To: DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU
Subject: [DCHAS-L] Cadaver lab ventilation; Dissection tables for 1) cadavers and 2) animals
I am seeking information regarding ventilation methods for a cadaver laboratory. In particular, we want to know the best way to achieve low formaldehyde levels, closer to the NIOSH recommended level of 0.016 ppm-TWA. Also, any specific
precedence or references you can share to help me inform/educate the decision makers why it is (or is not) in the institution's best interest to go by the NIOSH values rather than the OSHA values (0.75 ppm TWA for formaldehyde).
All this is in the context of a renovation and expansion. Any information on this would be greatly appreciated, including vendors for down-draft tables or other engineering control techniology (reviews, good+bad). Thanks!
Barry Ferm, CHO & Lab Coordinator, St. Ambrose University, Davenport Iowa,
fermbarreta**At_Symbol_Here**sau.edu
Previous post | Top of Page | Next post