Date: Wed, 21 Dec 2011 18:00:21 -0500
Reply-To: DCHAS-L <DCHAS-L**At_Symbol_Here**MED.CORNELL.EDU>
Sender: DCHAS-L Discussion List <dchas-l**At_Symbol_Here**med.cornell.edu>
From: ACTSNYC**At_Symbol_Here**CS.COM
Subject: Re: Eye protection for working w/borosilicate glass
X-To: dchas-l**At_Symbol_Here**med.cornell.edu

There's almost no UV coming off.  Instead it is IR and some sodium flare yellow.  There are weldingshades # 1 and # 2 that he might not find too dark.

Monona


In a message dated 12/21/2011 3:58:25 PM Eastern Standard Time, secretary@DCHAS.ORG writes:

From:  phil_mckittrick@yahoo.com


One of our labs uses sealed borosilicate glass tubes for some experiments.  A tech seals several dozen of the tubes with a torch (I know he is using oxygen, I think the fuel is propane, I know it is not acetylene) at onetime.  He was complaining about the brightness of the light, so is now wearing safety sunglasses that block 99+% UV.

Anyone have experience with something similar to this?  I have seen the didymium glasses that hobbyists use for glass blowing, but I am not surewhat eye protection to provide.  He has tried welders goggles, but found them too dark.

Thanks,

Phil McKittrick
Nalco Company


Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.