Date: Sat, 23 Oct 2010 13:04:00 -0700
Reply-To: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
Sender: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
From: DAVID KATZ <dakatz45**At_Symbol_Here**MSN.COM>
Subject: Re: Lab safety showers
In-Reply-To: <9FAC8FEB-8133-4AB5-B767-E5A498C557EB**At_Symbol_Here**uvm.edu>
<40FE1D2E-E340-4A66-B5A3-FD9A3A592594**At_Symbol_Here**whitman.edu>

At a previous place of employment, we took a 55-gallon drum, had it fitted with a standard water spigot on the side near the bottom, and built a cart with wheels for it.  The cart was high enough that a garden-type hose, attached to the spigot could be placed in a low sink so that the water could easily be drained. The cart was low enough to avoid a high center of gravity, so it would not tip over easily.  The wheels should be able to be locked.  It was easy to roll the semi-filled drum to an appropriate sink, or, if one was close by, just place the end of the hose into it.  We kept the hose short (under 10 feet) to keep it from being snaked across a room. 
 
David
____________________________________________________________________ _____
 
  David A. Katz             
  Chemist, Educator, Expert Demonstrator, Science Communicator, and Consultant  
  Programs and workshops for teachers, schools, museums, and the public
  133 N. Desert Stream Dr. * Tucson, AZ 85745-2277 *  USA
  voice/fax: (520) 624-2207 * email: dakatz45**At_Symbol_Here**msn.com
           Visit my web site:  http://www.chymist.com
___________ ______________________________________________________________
----- Original Message -----
From: Karen Smith
To: DCHAS-L**At_Symbol_Here**LIST.UVM.EDU
Sent: Friday, October 22, 2010 8:51 AM
Subject: Re: [DCHAS-L] Lab safety showers

Last May ANSI introduced standards that require an annual full 15 
minute flush and calculation of the flow rate of eye washes and 
showers.  As the person that checks all 64 eyewashes/ showers on 
campus let me say that floor drains would've been a godsend.   My 
showers will fill a 30 gallon bucket anywhere from 30 seconds to 1 
minute.   I tried using a sump pump to direct the water into a sink, 
but those drains are overwhelmed in 3 minutes.   Where I have windows 
that will open, I run the hose out the building.   For those that I 
don't have windows I haven't come up with a good solution yet.   Ideas 
anyone?   Physical plant has told me just to run hose from the lab on 
the 3rd floor all the way through the building and out the front 
door.    I understand the reasoning behind prohibiting floor drains - 
but can't they come up with drains that will remain closed until 
someone opens them?


Karen Smith, CSMM
Chemistry Stockroom Manager/ CHO
Whitman College
345 Boyer Ave.
Walla Walla, WA 99362
509 527-5272

On Oct 20, 2010, at 4:21 PM, List Moderator wrote:

> From: "Celia K. Williams" <ckvibe**At_Symbol_Here**gmail.com>
> Date: October 20, 2010 7:19:40 PM EDT
> Subject: Re: [DCHAS-L] Lab safety showers
>
>
> Has anyone recently installed safety showers in their labs? Do you
> have any tips you may share. We are following the ANSI standard but
> are there are recent guidelines?
> Thanks
> Celia
>
>

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.