Date: Mon, 3 May 2010 09:46:05 -0700
Reply-To: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
Sender: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
From: "Debbie M. Decker" <dmdecker**At_Symbol_Here**UCDAVIS.EDU>
Subject: Re: Formaldehyde filtration
In-Reply-To: <SNT116-W56AC1387302658CC49FEDCC4F00**At_Symbol_Here**phx.gbl>

Well – sort of!  Every embalmer has their own  220;secret sauce” (not my phrase!) to embalm cadavers and it’s usually a combination of 37.7% formaldehyde, low boiling alcohols, water, a little of this and a little of that.  For some embalmers, pH control is very important.  Embalming for dissection is a very different process from embalming for the funeral industry.

I worked with our embalmers on various management methods fo r their formaldehyde exposure, including monitoring, engineering controls and work flow adjustments.  They are an interesting bunch, to say the leas t!  In their new facility, many of the issues have gone away with good engineer ing.

In this application, it was important to understand the composition of embalming fluid being used, how they managed the “rins e” cycle and with what they replace embalming fluid to keep the cadavers in suitable condition for dissection over the course duration.

Sonia – I think we strayed way off topic from an answe r to your original question.  Did you get enough information to make a good recommendation?

Debbie

------------------------------

Debbie M. Decker, Campus Chemical Safety Officer
Environmental Health and Safety
University of California, Davis
1 Shields Ave.
Davis, CA  95616
(530)754-7964/(530)752-4527 (FAX)
dmdecker**At_Symbol_Here**ucdavis.edu
Co-Conspirator to Make the World A
Better Place -- Visit www.HeroicS tories.com and join the conspiracy

From: DCHAS-L Discu ssion List [mailto:DCHAS-L**At_Symbol_Here**LIST.UVM.EDU] On Behalf Of Alan Hall
Sent: Friday, April 30, 2010 10:35 PM
To: DCHAS-L**At_Symbol_Here**LIST.UVM.EDU
Subject: Re: [DCHAS-L] Formaldehyde filtration

Debbie,
 
You might remember that embalming fluid is a mixture of 70% formaldehyde an d 30% methanol.  The methanol should also be considered in safety evaluations.
 
Alan
Alan H. Hall, M.D.
Medica; Toxicologist
 

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.