Date: Fri, 10 Mar 2006 14:25:29 -0500
Reply-To: ILPI <info**At_Symbol_Here**ILPI.COM>
Sender: DCHAS-L Discussion List <DCHAS-L**At_Symbol_Here**LIST.UVM.EDU>
From: ILPI <info**At_Symbol_Here**ILPI.COM>
Subject: Re: Questions out of my realm
Comments: cc: ACTSNYC**At_Symbol_Here**CS.COM
In-Reply-To: <2a2.6ef02b0.3143086c**At_Symbol_Here**cs.com>

>All,
>
>I got the following two questions from a colleague and since I work in the
>art field, these are out of my area.  Can I get some help?
>
>1.  a student was boiling ether in a large open flask on a stirrer hotplate
>and the fume alone caught on fire, inside the hood. .  Do you have suggestions
>for them to reduce the ether amount for re-crystallization in a safer manner?

Yikes.  They should be using a rotary evaporator or some sort of 
simply vacuum line system.  There is no need to heat ether on a 
hotplate - ever!   Some general references:

	http://www.ilpi.com/inorganic/glassware/rotavap.html
	http://www.ilpi.com/inorganic/glassware/vacline.html

>2. a student in was quenching butyl lithium with n-propanol in an open flask
>and it also caught on fire.  Is there a safer way to quench the butyl lithium
>w;ithout catching on fire?

Usually, one lets flasks like that age quietly in an otherwise empty 
hood for a day or two before beginning the quench.  Give the flask a 
swirl once in a while.  If the solvent evaporates or it becomes too 
concentrated add some hexane or petroleum ether to dilute it.

n-propanol is too reactive for safe quenching.  Use isopropanol 
instead.  *Very* small amounts to start, followed by 
swirling/stirring and then waiting minutes or hours between the next 
aliquot.   The key is to quench slowly, never adding enough alcohol 
to raise the temperature of any part of the flask - watch out 
particularly for localized heating or the formation of solid chunks 
that may shield their core from quenching.

You can keep a blanket of dry nitrogen over the system to exclude 
oxygen as an added precaution, but as long as you aren't being 
"greedy" by trying to quench too fast this shouldn't be an issue.

There is always a degree of risk in a quench, so these are just 
typical guidelines, not hard and fast rules.  If the solvent catches 
fire, remember that placing a watch glass over the top will snuff. 
Most quenching accidents I have seen come from folks panicking or 
trying to quench too rapidly.

Rob
-- 
   =====================================================
Safety Emporium - Lab & Safety Supplies featuring brand names
you know and trust.  Visit us at http://www.SafetyEmporium.com
esales**At_Symbol_Here**safetyemporium.com  or toll-free: (866) 326-5412
Fax: (859) 523-0606, 4905 Waynes Blvd, Lexington, KY 40513-1469

Previous post   |  Top of Page   |   Next post



The content of this page reflects the personal opinion(s) of the author(s) only, not the American Chemical Society, ILPI, Safety Emporium, or any other party. Use of any information on this page is at the reader's own risk. Unauthorized reproduction of these materials is prohibited. Send questions/comments about the archive to secretary@dchas.org.
The maintenance and hosting of the DCHAS-L archive is provided through the generous support of Safety Emporium.